12
Using The 1D RF Laser Setup Menu
Note: If you are using the 2D 520-RF then refer to the 2D setup chart starting on page 24.
1.
To configure your reader using the
RF Laser Setup Menu
, you must first scan the
Start Setup
code at the
top left corner.
Do this now
. You'll hear two beeps. During Setup, nothing will be transmitted to your
computer; the
Reader Setup Menu
codes are strictly for configuring the reader. If you did not hear two
beeps, try scanning the code again, until you hear the two beeps. If you've never scanned bar codes before,
read the scanning instructions on
page 6
before continuing. The scanner LED will turn green when in
setup mode.
2.
Next, choose the setting you want to change an option for and scan its code. You will hear 2 beeps each
time you read a setup barcode.
3.
Then, choose the option you want to change, from the list next to the setting bar code you just scanned.
Using the "
Barpad Table
" on the right side of the Reader Setup Menu, scan the number or letter associated
with the option you have selected to change. Some settings (like Preamble and Postamble) require the
SET
barcode to terminate a string entry but most are single character.
4.
Now scan
End Setup
(at the top-right corner of the Reader Setup Menu to complete the setup. You'll hear
three beeps.
The next several pages will show you all of the various Wireless Reader options. Default settings are shown
in
bold
in this manual and marked with an
*
on the
Reader Setup Menu
.
Summary of Contents for 520-RF
Page 1: ......
