Workrite Ergonomics | 800.959.9675 www.workriteergo.com
9 of 12
Install Switch
Install your Switch (E) using two
3.5 mm × 16 mm Pan Head Screws (F).
If you have a Workrite pre-drilled
Worksurface:
Locate the pre-drilled holes near the
front edge of the Worksurface and
attach.
If you have a non-Workrite top:
Align the switch with the front edge of
the top, use a ⅛" drill bit to drill pilot
holes using the Switch holes as a guide
and attach.
Do not drill all the way through worksurface!
Attach Collision Detection Sensor to Frameset and
Worksurface
Attach the two Round Bumpers (X) to
the contact surface of the Collision
Detection Sensor (N).
Place the bumpers down, contacting
the worksurface and position on
Frameset (C) as shown. Attach
Collision Detection Sensor (N) to
worksurface with one #8 × ¾"
Phillips Head Wood Screw (P).
Attach the Collision Detection Sensor
(N) to the Frameset (C) in location
shown using the two #8 × ¾" Self
Tapping Screws (O). You will need
to apply pressure with the screw in
place to make the "bit" of the screw
drill into the frame then catch to
attach and hold secure.
9
E
F
8
a
b
c
b
Use Self Tapping Screws
(O) to drill into frame.
Alternative location
O
#8 × ½" Self Tapping
Phillips Head Screw
P
#8 × ¾" Phillips Pan
Head Wood Screw
Hardware at actual size
Hardware at actual size
N
N
N
P
X
C
c
c
a
O
Improper installation of the Anti
Collision Detection System may result
in false collision incidents. Please
follow instructions closely.
CDS mount location
