8 of 12
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
1.5"– 2"
1.5"– 2"
7.2"
7.2"
1
3
4
5
6
7
2
9
10
11
12
8
>¾"
1.5"– 2"
1.5"– 2"
7.2"
7.2"
1
3
4
5
6
7
2
9
10
11
12
8
>¾"
Attach Frameset to Non- Workrite Top
With Frameset positioned correctly from
Step 5, use a ⅛" drill bit to drill pilot holes in the twelve frameset
mounting locations shown.
You may wish to mark your drill bit so you do not drill any more than ¾" deep to avoid damaging your
worksurface top.
Do not drill all the way through worksurface!
With frame set positioned over pilot holes, lift Frameset (C) to place the Power Supply Bracket (H) under the
Frameset at location shown.
With frame set positioned, lift Frameset (C) to place twelve 20 mm Foam Washers (K) at all frame mount
locations UNDER the frameset. Be sure to keep frameset aligned with pilot holes.
Attach the Side Bars (D) to the worksurface using four of the 16 mm Steel Washers (L), four 20 mm Foam Washers
(K) and four #8 × 1" Pan Head Phillips Wood Screws(M).
Attach the Frameset (C) with six 16 mm Steel Washers (K), six Foam Washers (J) and eight of the longer 3/16 × 2⅛"
Flat Head Phillips Wood Screws (V).
NOTE: No 16 mm Steel Washers (K) and only one BOTTOM Foam Washer (J)
are used in the Joining Bracket center frame location.
7
a
b
b
Mark drill bit so you do not
drill through your top
a
a
c
c
c
c
d
d
e
e
e
K
K
K
K
K
M
W
W
C
C
D
L
L
Joining Bracket location,
bottom Foam Washer (K) only.
H
CC
Mark
K
located between
frameset and worksurface
K
located
between frameset
and worksurface
