Workrite Ergonomics | 800.959.9675 www.workriteergo.com
7 of 12
Attach Frameset to Workrite Pre-Drilled Worksurface
If you do not have a Workrite Pre-drilled Worksurface, skip to
Step 7.
Position Frameset on the underside of the Worksurface to align mounting holes in brackets to pre-drilled holes
in worksurface.
With Frameset positioned, carefully lift Frameset (CC) to place the Power Supply Bracket (H) under the Frameset
at location shown.
Carefully lift the Frameset to place twelve 20 mm Foam Washers (K) at all frame mount locations UNDER the
frameset as shown. Be sure to keep frameset aligned with pre-drilled holes.
Attach the Side Bars (D) to the worksurface using four of the 16 mm Steel Washers (L), four 20 mm Foam Washers
(K) and four #8 × ¾" Pan Head Phillips Wood Screws(M).
Attach the Frameset assembly with six 16 mm Steel Washers (L), six Foam Washers (K) and eight of the longer
3/16 × 2⅛" Flat Head Phillips Wood Screws (W).
NOTE: No 16 mm Steel Washers (L) and only one BOTTOM Foam
Washer (K) are used in the Joining Bracket center frame location.
With frame securely fastened to the worksurface, re-tighten the Joining Brackets loosened in
Step 3a.
Proceed to
Step 8.
6
K
K
K
a
a
b
c
c
c
d
e
f
e
e
W
W
C
C
L
M
#8 × ¾ Phillips Pan Head
Wood Screw
W
#10 × 2½" Phillips Pan Head Wood Screws
Hardware at actual size
Hardware at actual size
NOTE
Attaches Side Bars (D) to Worksurface.
NOTE
Attaches Framesets (C & CC) to Worksurface.
Joining Bracket location,
bottom Foam Washer (J) only.
b
H
CC
K
located
between frameset
and worksurface
K
20 mm Foam Washers
Hardware at actual size
K
K
c
d
M
D
L
K
located between
frameset and worksurface
f
Retighten
