Assembly
3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
9
Step 1 (Continued): Installing the legs.
8. Insert a 1/2” washer, lock washer and hex bolt
(5/16-18”x 3/4”) into the side panel on the side of
the leg.
9. Tighten a 5/16” flange nut onto the other side of
the bolt located inside of the dryer. Tighten the bolt
and nut with a socket wrench and wrench. Repeat
steps 8-9 for the other side panel on the same leg.
10. Repeat steps 8-9 for the other three legs. In total
eight holes should be filled with the designated nut
and bolt.
11. At this point the legs should match the photo
above. The “J” and the two side panels should be
installed for every leg.
