Settings in the service menu
51
Greenstar 4000 – 6 720 891 162 (2020/09)
7.2
Service menu
7.2.1
Overview of the service menu
Benchmark
– Flow temp.
Info
– Current status
– Current fault
– Fault history
– Boiler
– Max. heat output
– Actual temp.
– Set flow temp.
– HEx temperature
– Act. burner mod.
– Burner output
– Ionisation current
– Pump mod.
– Outside temp.
– Burner starts
– Hours run
– System pressure
– Hot water
– Max. output
– DHW act. temp.
– S Act.temp. cyl.
1)
– DHW set temp.
1)
– System
– Contr.device ver.
– Progr. unit ver.
– SW sub-ver.
– Code plug no.
– Code plug ver.
– Key
2)
– Solar
3)
– Collector temp.
– Cyl.temp.bottom
– Collector pump
– Solar fault
Settings
– Hydraulics
– Low-loss header
– DHW configuration
– HC1 configuration
– Pump config.
– Heating
– Max. heat output
– Standby time
– Anticyc. temp. off
– Anticycle temp. on
– Hot water
– Max. output
– DHW circ. pump
– Cycle circ. pump
– TD-Temperature
– Start TD
– Pump
– Pump range map
– Pump ctr. mode
– Min. output
4)
– Max. output
– Pump overrun
– Special function
– Ventilation func.
– 3-WV mid. pos.
– Maintenance
– Maintenance type
– Without (off)
– Burner run time
– Boiler run time
– Service date
– Landlord
– End date
– Maint. reminder
– Installer tel. no.
– Limit values
– Max. flow temp.
– Max. DHW temp.
– Min. boiler outp.
– Heating curve
– Enable
– Htg. curve base
– Htg. curve end
– Summer mode
– Frost prot.
– Frost temp. limit
1) Menu item only visible if integral diverter kit is fitted.
2) Only available with installed Key Timer (accessory).
3) Not available in every system configuration.
4) Available when
Pump range map
has been changed to
Output dependent
