http://www.woosim.com
55
4) The horizontal starting buffer position does not move.
5) The reference starting position is that specified by ESC T.
6) This command operates as follows, depending on the starting position of
the printing area specified by ESC T; When the starting position is set to the
upper left or lower right, this command sets the absolute position in the
vertical direction. When the starting position is set to the upper right or
lower left, this command sets the absolute position in the horizontal
direction.
7) The horizontal and vertical motion unit are specified by GS P.
8) The GS P command can change the horizontal and vertical motion unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
[Reference]
ESC $, ESC T, ESC W, ESC \, GS P, GS \
GS \ nL nH
[Name]
Set relative vertical print position in page mode
[Format] ASCII
GS
\
nL
nH
HEX
1D
5C
nL
nH
Decimal
29
92
nL
nH
[Range]
0
˺
nL
˺
255
0
˺
nH
˺
255
[Description]
Sets the relative vertical print starting position from the current position in
page mode.
[Notes]
1) This command sets the distance from the current position to [(nL +
nHx256)] x vertical or horizontal motion unit inches.
2) This command is ignored unless page mode is selected.
3) When pitch N is specified to the movement downward;
nL + nHx256 = N When pitch N is specified to the movement upward (the
negative direction), use the complement of 65536.
