http://www.woosim.com
52
dy = [(dyL + dyH * 256)] * (vertical motion unit)
The printing area is set as shown in the figure below.
[Note]
1) If this commands is input in standard mode, the printer executes only
internal flag operation. This command does not affect printing in standard
mode.
2) If the horizontal or vertical starting position is set outside the printable
area, the printer stops command processing and processes the following
data as normal data.
3) If the printing area width or height is set to 0, the printer stops command
processing and processes the following data as normal data.
4) This command sets the position where data is buffered to the position
specified by ESC T within the printing area.
5) If (horizontal starting po printing area width) exceeds the
printable area, the printing area width is automatically set to (horizontal
printable area - horizontal starting position).
6) If (vertical starting po printing area height) exceeds the printable
area, the printing area height is automatically set to (vertical printable area-
vertical starting position).
7) The horizontal and vertical motion unit are specified by GS P. Changing
the horizontal or vertical motion unit does not affect the current printing
area.
8) The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of minimum horizontal movement
amount.
9) Use the horizontal motion unit (x) for setting the horizontal starting
position and printing area width, and use the vertical motion unit (y) for
setting the vertical starting position and printing area height.
10) When the horizontal starting position, vertical starting position, printing
area width, and printing area height are defined as X, Y, Dx, Dy
respectively, the printing area is set as shown in the figure below.
