Smart View
Set up a Connection via Serial Interface under Windows XP
After installation of the software, the »Connection PC/Notebook to the Device« has to be configured once so that
you are able to read device data or re-write them into the device by means of the software
Smart view.
For connection of your PCs/notebooks with the device, you need a zero-
modem cable (no serial cable!/please refer to chapter »Zero Modem
Cable«).
If your PC/notebook does not have a serial interface, you need a special
»USB-to-serial-adapter«. Only if the »USB-to-serial-adapter« is correctly
installed - aided by the provided CD – the communication with the device
can be established. (see next chapter).
Setting up/Configuring the connection
•
Connect your PC/notebook with the device via a zero-modem cable.
•
Start the software
Smart view
.
•
Select the menu point »Device Connection« in menu »Settings«.
•
Click on »Serial Connection«.
•
Click button »Settings«.
•
When initially setting up the connection, a dialogue window appears with the information that, so far, a
direct connection with your protection device has not been established. Click on »Yes«.
•
If, so far, a location has not been set up on your PC, your location information has to be put in. Confirm
the following pop-up window »Telephone and Modem Options« with »OK«.
•
The Windows network connection assistant appears after the location information is set up. Select the
connection type »Establish direct connection to another computer«.
•
Select the serial interface (COM-Port) where the device shall be connected to.
•
Select »To be used for all users« in window »Availability of the connection«.
•
Do not change the connection name appearing in window »Name of the connection« and click the button
»Complete«.
•
Finally you arrive again in window »Device Installation« from where you started establishing the
connection. Confirm the adjustments by clicking the »OK« button.
EN MRU4 10/09
Page 53
