Manual
Manual 37223E
37223E
easYgen-3000
easYgen-3000 Series
Series (Package
(Package P1)
P1) -
- Genset
Genset Control
Control
Page
Page 14/67
14/67
©
© Woodward
Woodward
Clamp Fastener Installation
Clamp Fastener Installation
For installation into a
For installation into a door panel with the fastening clamps, proceed as follo
door panel with the fastening clamps, proceed as follows:
ws:
1.
1.
Panel cutout
Panel cutout
Cut out the panel according to
Cut out the panel according to the dimensions in
the dimensions in Table 4-1.
Table 4-1.
Note:
Note:
Don't drill the holes if
Don't drill the holes if you want to use the clamp fasteners. If the holes are
you want to use the clamp fasteners. If the holes are
drilled into the p
drilled into the panel, the clamp fasteners cannot be used anymore!
anel, the clamp fasteners cannot be used anymore!
cut-out
cut-out
186,0
186,0
138,0
138,0
R3,5
R3,5
Rmax:
Rmax:
2.
2.
Remove terminals
Remove terminals
Loosen the wire connection terminal screws on the back of the unit and
Loosen the wire connection terminal screws on the back of the unit and
remove the wire connection terminal strip if required.
remove the wire connection terminal strip if required.
3.
3.
Insert screws in clamps
Insert screws in clamps
Insert the four clamping screws into the clamp inserts from
Insert the four clamping screws into the clamp inserts from the shown side
the shown side
(opposite of the nut insert)
(opposite of the nut insert) until they are almost flush. Do not completely
until they are almost flush. Do not completely
insert the screws into the clamp inserts.
insert the screws into the clamp inserts.
4.
4.
Insert unit into cutout
Insert unit into cutout
Insert the unit into the panel cutout. Verify that the unit fits correctly in
Insert the unit into the panel cutout. Verify that the unit fits correctly in
the cutout. If the panel cutout
the cutout. If the panel cutout is not big enough, enlarge it accord
is not big enough, enlarge it accordingly.
ingly.
5.
5.
Attach clamp inserts
Attach clamp inserts
Re-install the clamp inserts by tilting the insert to a 45° angle. (1) Insert
Re-install the clamp inserts by tilting the insert to a 45° angle. (1) Insert
the nose of the insert into
the nose of the insert into the slot on the side of
the slot on the side of the housing. (2) Raise the
the housing. (2) Raise the
clamp insert so that it is parallel to the control panel.
clamp insert so that it is parallel to the control panel.
1
1
2
2
6.
6.
Tighten clamping screws
Tighten clamping screws
Tighten the clamping screws (1) until the control
Tighten the clamping screws (1) until the control unit is secured to the
unit is secured to the
control panel (2).
control panel (2). Over tightening of these screws may result in the clamp
Over tightening of these screws may result in the clamp
inserts or the housing breaking. Do not exceed t
inserts or the housing breaking. Do not exceed the recommended tighten-
he recommended tighten-
ing torque of 0.1 Nm.
ing torque of 0.1 Nm.
1
1
2
2
7.
7.
Reattach terminals
Reattach terminals
Reattach the wire connection terminal strip (1)
Reattach the wire connection terminal strip (1) and secure them with the
and secure them with the
side screws.
side screws.