32
Assembly
MAN1048 (4/16/2014)
INSTALL DRIVELINE
(FIGURE 28)
Select either the standard shear bolt or optional slip
clutch driveline.
Figure 28
. Shear Bolt and Slip Clutch Assembly
Shear Bolt Driveline
NOTICE
■
A grade 2 bolt must be used for the shear bolt to
provide gearbox protection.
1.
Position clutch shield (1) against gearbox. Secure
using cap screw (2), lock washers (3), and flat
washers (4). Torque hardware to 12 lbs-ft.
2.
To prevent seal damage, carefully push
driveline(6) onto gearbox input shaft until it
contacts the gearbox housing.
3.
Place retaining ring (5) in slot on input shaft and
snap into place.
4.
Align the holes in the driveline (6) yoke and
gearbox input shaft. Install and tighten shear bolt
(7) and nut (8).
5.
Lubricate rear driveline half and install front
driveline half.
Driveline Slip Clutch
NOTICE
■
A grade 8 bolt must be used to attach clutch
driveline to gearbox.
A new slip clutch, or one that has been in storage over
the winter, may seize.
1.
Before operating slip clutch, make sure it will slip.
Refer to
Slip Clutch Adjustment, page 19
.
2.
Position clutch shield (1) against gearbox. Secure
using cap screw (2), lock washers (3), and flat
washers (4). Torque hardware to 12 lbs-ft.
3.
Install driveline (9) onto gearbox input shaft and
secure with bolt (10) and nut (8).
4.
Lubricate rear driveline half and install front
driveline half.
1. Clutch shield
2. 5/16 NC x 3/4 Cap screw
3. 5/16 Lock washer
4. 5/16 Flat washer
5. Retaining ring
6. Shear bolt driveline
7. 1/2 NC x 3 Cap screw GR2
8. 1/2 NC Lock nut
9. Slip clutch driveline
10. 1/2 NC x 3 Cap screw GR8
