20
Owner Service
MAN1048 (4/16/2014)
DRIVELINE SHEAR BOLT REPLACEMENT
NOTICE
■
Always use approved 1/2" NC x 3" grade 2 shear
bolt as a replacement part. Using a hardened bolt
or shear pin may result in damage to driveline or
gearbox.
1.
Remove damaged shear bolt (7).
2.
Rotate driveline (6) to align holes in yoke and shaft.
Install shear bolt and secure with lock nut (8).
Figure 13
. Shear Bolt Driveline Assembly
SHIELDING REPAIR
Full chain, rubber, or steel band shielding must
be installed when operating in populated areas or
other areas where thrown objects could injure peo-
ple or damage property.
• If this machine is not equipped with full chain,
rubber, or steel band shielding, operation must
be stopped when anyone comes within 300 feet
(92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition. It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
Rear Band
Inspect rear band each day of operation and replace if
bent, cracked or broken.
Rubber Shielding
Inspect rubber shielding each day of operation and
replace if cracked or broken.
Optional Chain Shielding
Inspect chain shielding each day of operation and
replace any broken or missing chains as required.
CLEANING
After Each Use
●
Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
●
Inspect machine and replace worn or damaged
parts.
●
Replace any safety decals that are missing or not
readable.
Periodically or Before Extended Storage
●
Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
●
Remove the remainder using a low-pressure water
spray.
1.
Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2.
Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3.
If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
●
Inspect machine and replace worn or damaged
parts.
●
Sand down scratches and the edges of areas of
missing paint and coat with Woods spray paint of
matching color (purchase from your Woods
dealer).
●
Replace any safety decals that are missing or not
readable (supplied free by your Woods dealer).
See Safety Decals section for location drawing.
1. Clutch shield
2. 5/16 NC x 3/4 Cap screw
3. 5/16 Lock washer
4. 5/16 Flat washer
5. Retaining ring
DANGER
