Sawmill Alignment
Complete Alignment Procedure
5
5-43
HDSdoc021716
Sawmill Alignment
See Figure 5-39.
To adjust the saw head tilt, use the bolts located at the bottom of the saw head mast.
Loosen the three sets of four retaining plate bolts. To raise the outside of the saw head, back the stop bolts
out, then tighten the adjustment bolts. To lower the outside of the saw head, loosen the adjustment bolts and
tighten the stop bolts. Recheck the measurement from the blade to the bed rails and adjust the stop bolts
and adjustment bolts until the outside of the saw head is 1/16" higher than the inside..
FIG. 5-39
600011-4a
Stop Bolt
DETAIL OF LOWER TRACK ROLLER ASSEMBLY
Stop Bolt
Adjustment Bolt
Retaining
Plate Bolts
Tighten adjustment
bolts to raise saw head;
Loosen adjustment
bolts to lower saw head
Adjustment Bolt
