Sawmill Alignment
Complete Alignment Procedure
5
5-39
HDSdoc021716
Sawmill Alignment
Blade Disk Adjustment
1.
Remove the blade and remove the alignment bars from the blade guide assemblies. Install new or
reconditioned bottom guide disks to both blade guide assemblies (leave mounting bolts loose). Use the
provided bottom disk adjustment tool to lower the bottom disk all the way down. Install, tension and track the
blade.
See Figure 5-36.
2.
Use the bottom disk adjustment tool to raise the bottom disk to 0.3-0.5 mm from the blade. Use the provided
shim to set the distance from the disk to the blade. Tighten the bottom disk mounting bolt and clamp bolt.
3.
Turn the top disk adjustment bolt clockwise to lower the top disk to 0.3 -0.5 from the blade (using the shim as
a guide). Tighten the top disk mounting bolt and clamp bolt.
4.
After tightening the clamp bolt, recheck the distance from the top disk to the blade and readjust if necessary.
FIG. 5-36
600122-19C
Tighten mounting
and clamp bolts
Use bottom disk
adjustment tool to
raise bottom disk
Tighten mounting
and clamp bolts
Turn adjustment bolt
clockwise to lower top
disk
