Sawmill Alignment
Complete Alignment Procedure
Sawmill Alignment
HDSdoc021716
5-38
5
mounting bolt.
2.
Check that the gap from the alignment bar to the blade is the same along entire length of the bar. Shine a
flashlight behind the blade guide assembly to help you see the gap between the bar and the blade. To
adjust, loosen the rear clamp bolts, but leave snug. Determine which outer bolt to use to tilt the blade guide
assembly as desired. Loosen the jam nut and turn the bolt until the alignment bar is parallel to the blade.
Retighten the jam nut and clamp bolts. Repeat for the second blade guide assembly.
See Figure 5-35.
FIG. 5-35
600041
Loosen rear
clamp bolts
Check gap between blade and
alignment bar (See Detail)
Use bottom disk
adjustment tool to raise
alignment bar close to
blade
Outer tilt
adjustment bolts
Blade has the
same distance
from bar along
entire length of bar
DETAIL
