www.WoodMaxx.com
23
Slowly engage the tractor’s hydraulic 3-Point hitch to lower the implement while
checking for sufficient drawbar clearance. Move the drawbar ahead, aside, or
remove if required.
If needed, set the tractor’s 3-Point hitch lift height to keep the PTO Shaft from
exceeding the maximum allowable length and 25° up or down.
Maximum PTO Shaft Movement During Operation - Figure 4
Checking The PTO Shaft’s Interference
(Refer to Figure 4)
CAUTION:
Contact with the driveline while in use can result
in serious injury or death. Any portion of the driveline while not
shielded must be guarded by an interactive guarding system.
Any replacement guard must be one which is specified by the
manufacturer. In short, do not remove any of the plastic safety covers
on the driveline and insure that caution is used around this driveline.
No one should be in the driveline area when it is operating.
PTO SHAFT SIZING INSTRUCTIONS
PTO SHAFT SIZING INSTRUCTIONS
Summary of Contents for WM-8M
Page 1: ......
Page 58: ...3 20...
