www.WoodMaxx.com
13
25°
Assembly Instructions
(continued)
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
• Locate the lift point on the top of the
chipper. This is the balance point, and the
only point the chipper should be lifted from.
• Using a chain or strap that is rated strong
enough to lift the weight of the chipper,
and the lift pin (not provided) lift the
chipper out of the crate.
• If you do not have a front end loader,
attach the three point hitch of your
tractor to the chipper to lift the chipper
out of the crate.
STEP 3
STEP 4
STEP 5
• Measure the distance from the PTO spline
of your tractor to the ground. Write down
this measurement here ________. You will
need it for the next step.
• While the chipper is raised in the air,
attach the four adjustable base legs so
that when the chipper is on the ground,
the spline of the chipper is slightly lower
than the spline of your tractor.
• The shaft does not need to be perfectly
horizontal, but it is recommended that
the slope of the PTO shaft is no more
than 25° degrees.
• Attach the skid shoe base plates as
shown using the included carriage bolts
and nuts. At this time, carefully lower the
chipper to the ground, and remove the
chain or strap.
STEP 6
Summary of Contents for WM-8M
Page 1: ......
Page 58: ...3 20...
