Post Sleeve Bushing Replacement
Most Sawmill Models
FULLY TIGHTEN HARDWARE
With the bushings properly nested together and flush with the carriage post, secure them by
fully tightening all sixteen (16) hex bolts with a socket/wrench.
Once all the bushings are fully tightened, spray the posts with a water resistant silicone lubricant
such as “
WD-40 Water Resistant Silicone Spray
” or “
3-in-One Silicone Spray Lubricant
.”
The bushing replacement is now complete. If applicable, reinstall and calibrate the adjustable
blade guide assembly as shown in the next section.
PSBR-MY2020-EN: Rev A
Page
of
14
16
29-Jul-2020
Be sure to adjust the
sawhead depth stop jam
nut on both sides of the
sawmill when tightening
the bolts
The new bushings are
5/32 in [4 mm] thicker than
the previous style so the
bolt needs to protrude less
than it was originally. Set
these bolts so the blade is
1 in [25 mm] above the log
bunk when the head is
lowered all the way down.
UPPER
LOWER
