Post Sleeve Bushing Replacement
Most Sawmill Models
ASSEMBLE LOWER POST SLEEVE BUSHINGS
Follow the steps below to assemble the U-shaped post sleeve bushings to the bottom face of
the post sleeve. Repeat the steps for both sides of the mill.
PSBR-MY2020-EN: Rev A
Page
of
12
16
29-Jul-2020
Angle the front bushing upwards
and push it over the front side of
the carriage post. The bushing
will fit tightly over the post.
Push the bushing up until it lies
flat against the post sleeve.
Push the rear bushing over the
back side of the carriage post
until it fully nests with the front
bushing.
Reinstall the locking plate and
the four (4) hex bolts—but only
start the threads. Do
not
tighten
the bolts until instructed.
Note: after each set of bushings
are installed, it is normal to have
to move the sawhead to get all
the bolts started in the holes.
