-10-
FIG.5.6
FIG.5.7
FIG.5.8
FIG.5.9
5.6 MOUNT THE BENCH DRILL PRESS
The bench drill press must be securely fastened through
the mounting holes (1) to a stand or workbench
with heavy-duty fasteners. This will prevent the bench
drill press from tipping over, sliding, or walking during
operation. FIG.5.6
5.7 LED BULB
Insert the LED bulb (1) into the socket (2) in the motor
head assembly. FIG.5.7
5.9 TO REMOVE THE CHUCK
- Turn the feed handles (1) to lower the chuck (2) to the
lowest position.FIG.5.9
- Place a ball joint separator (3; not included) above the
chuck and tap the separator lightly with a hammer (4; not
included) to cause the chuck to drop from the spindle.
FIG.5.9
5.8 TO INSTALL THE CHUCK
- Inspect and clean the taper hole in the chuck (1) and the
spindle (2). Remove all grease, coatings, and particles
from the chuck and spindle surfaces with a clean cloth.
FIG.5.8
- Open the chuck jaws (3) by manually turning the chuck
barrel clockwise. Make sure the jaws are completely
recessed inside the chuck.FIG.5.8
- Insert the chuck arbor (4) into the opening at the top of
the chuck (1).FIG.5.8
- Seat the chuck and chuck arbor on the spindle by
placing a block of wood (5; not included) under the chuck
(1) and tapping the wood with a hammer (6; not included)
or tap the chuck with a rubber mallet (not included).
FIG.5.8
CAUTION
CAUTION
CAUTION
CAUTION
If the stand or workbench has a tendency to move during
operation, fasten the workbench securely to the floor.
LED bulb can be replaced by any 120V 8L LED bulb if the
original one runs out of its lifetime. Install the replacement
LED bulb the same way you install the original one.
To avoid damaging the chuck, make sure the jaws are completely
recessed into the chuck. Do not use a metal hammer to drive the
chuck into the spindle.
To avoid possible damage to the drill or chuck, be
prepared to catch the chuck as it falls.
