Minimum Required Forklift Capacities
Model
Shipping Weight
(kg/lbs)
Required Forklift
Capacity (lbs/kg)
Min. Fork
Length (ft/m)
PX-4343-LR
953 kg
(2,100 lbs)
1450 kg
(3,200 lbs)
1.5m
(5')
PX-4355-LR
1134 kg
(2,500 lbs)
2268 kg
(5,000 lbs)
PX-4836-LR
816 kg
(1,800 lbs)
1450 kg
(3,200 lbs)
The oven should
only be moved using
a Pallet Jack on a
smooth, LEVEL FLOOR.
Use a Forklift
or other suitable
means if the oven
must be moved over
an inclined surface.
LEVELING AND SHIMMING THE OVEN
.
The installed oven must be level. Use metal shims to level the oven if necessary. Because the weight of the oven is carried by the full
perimeter of the oven stand, make certain there no gaps larger than approximately 13mm (1/2") where the oven stand is unsupported
by shims. Seal any small gaps between the oven and the floor with silicone. Failure to solidly support the full perimeter of the oven
stand can result in costly damage to the oven and will void the warranty. The floor design and construction must be adequate to
handle the weight of the oven.
Please see
woodstone-corp.com
for floor loading information.
USING A FORKLIFT | PALLET JACK
Phoenix ovens are very top-heavy.
If the oven tips it can
cause severe injury or death. Never use a Hand Truck to
move the oven. The oven should only be moved using a
Pallet Jack on a smooth, LEVEL FLOOR.
If the oven must
be moved over an inclined surface, a Forklift or other suitable
means should be employed. If the installer does not have the
equipment or experience required to move the oven safely, we
recommend securing the services of a qualified rigging company.
The oven should only be moved using a Pallet Jack on a
smooth, LEVEL FLOOR.
Ü
Ü ÜÜ
Make sure the
Pallet Jack wheels
do not contact the
underside of the
fork pocket when
lifting to avoid
damaging the stand.
PICKEYE CAPACITIES PER BEAM
907 kg (2,000 lbs):
Middle holes
(PX-4343-LR, PX-4355-LR)
1225 kg (2,700 lbs):
Outer holes
(PX-4836-LR)
INNER
INNER
MIDDLE
MIDDLE
OUTER
OUTER
BOLT POSITIONS
Never use a Hand Truck
to move the oven.
MOVING THE OVEN
.
LOAD
Orient Spreader Bar
as shown in fig. 1
50°MIN Angle
WARNING
If you received your Phoenix oven disassembled, go to the ASSEMBLY section.
If you need to disassemble the oven to move it through a narrow door or passageway,
see the DISASSEMBLY section in this manual.
If the oven is to be installed against a wall, leave access to the back of the oven to complete the utility connections.
Pickeye
Beam
Shown:
BL-4343-LR
fig. 1
USING A CRANE
.
The oven arrives with Pickeyes attached. When craning a Wood Stone oven, use a Spreader Bar with a
two-legged sling rigged on each end. The spreader bar should be of a sufficient length to keep the sling
from contacting the oven, and oriented as shown in fig 1.
Dual Burner Phoenix Installation
and Operation Manual
PG
9
OF
32
M0030.10 JANUARY 2020
MOVING & PLACING THE OVEN