Controller will not turn on
Flame does not light
Flame cuts out
Display reads “OPEN”
1.
Incoming power to oven turned off. Check circuit breaker for circuit
supplying the oven. Check that any wall switches external to the oven
that control oven power are turned on. Check that any interlocks external
to the oven are turned on.
2.
If controller still does not turn on, please contact Wood Stone for
assistance.
1.
Debris in burner.
2.
Oven is being run with the night door in place. Night Heat Retention Door
must be removed whenever the oven is turned on.
3.
Wind blowing into the oven, or other venting issues.
1.
Thermocouple is not plugged into control box.
2.
Damaged thermocouple. Contact your distributor for assistance.
PROBLEM CAUSE/SOLUTION
1.
Check gas is turned on to the oven, and gas shut-off valve is turned all
the way on.
2.
Debris in burner. Burner may require cleaning. Contact your distributor
for assistance.
3.
Damaged igniter or gas valve. Contact your dealer for assistance.
If the oven is being started for the first time:
- Has all air been bled from the gas line?
- Is the switch on the SV-2 and SV-3 valve in the ON position?
NOTE:
Valves are locate on the back of the control box, beneath the
oven.
Dual Burner Phoenix Installation
and Operation Manual
PG
29
OF
32
M0030.10 JANUARY 2020
An ongoing program of product improvement may
require us to change specifications without notice.
WOOD STONE CORPORATION
1801 W. Bakerview Rd.
Bellingham, WA 98226 USA
TEL
+1.360.650.1111
FAX
+1.360.650.1166
woodstone-corp.com
TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE