OPERATION
Controller Operation in Pre-defined Head Return Height Mode
2
2-8
SW-10doc111419
OPERATION
position
.
Only the first cut position has to be set manually.
NOTE:
After making the first cut you will not need to set the head height
manually.
2.4
Controller Operation in Pre-defined Head Return Height Mode
If you want to saw without removing each cut board, you should preprogram the head return height.
It is possible to program two head return height values (See Point 5. Setting a Head Return Height in BUMP
UP Function).
Programming the head return height:
Position the head above the log or cant so that it clears the log/cant when being returned.
Press and hold
until the lamp shown on the picture below starts lighting.
See Figure 2-4.
FIGURE 2-4
.
