OPERATION
Pattern Modes
OPERATION
SW-10doc111419
2-11
2
2.6
Pattern Modes
To create a series of cuts calculated from the bed level, use one of the Pattern modes: Manual Program or
Quick Program.
These two modes can be used for entering a program for cutting one log only. Such programs are not saved
in the controller memory and are deleted when the cutting operation is completed.
2.6.6 ‘’Manual Program” Mode
Entering a Program in the ’’Manual Program” Mode
Position the saw head at the height of the top end of the log.
Push
. The ’’Program” light will come on and ”P- 1” will appear on the display.
Using the keypad, enter the dimension of the first board calculated from the sawmill bed.
Press
and enter the next board thickness. Repeat until the total of the entered board
thicknesses, plus the kerf value calculated by the controller, exceeds the blade height value. It will be
signaled by blinking of the value in the upper display window.
CAUTION!
You can at any time raise the saw head manually, using the
up/down switch, and add next board ticknesses to the program. The Remote
mode has to be disabled.
Push
to position the blade at the height of the first cut.
CAUTION!
If you want to saw in the Manual Program mode without removing
each cut board - once the blade is set at the height of the first cut - position the
blade above the log or cant so that it clears the log/cant along its entire length.
Complete entering of the program by pushing
. If the head return height was preset, the
’’Height” light will come on indicating that this value was saved.
CAUTION!
If ’’Pres cut” is displayed after pushing
, the blade is not set
at the height of the first cut and you have to press
to perform this
setting.
