OPERATION
Operation in Normal Mode
OPERATION
SW-10doc111419
2-7
2
- To save the parameter, push
.
2.3
Operation in Normal Mode
CAUTION!
The minimum thickness of the last board (when using the
automatic modes) cannot be lower than
30 mm
[LT15, LT20 and WM1000
sawmills] or
50mm
[LT40 sawmills]. To cut a thinner board, you need to
manually lower the saw head.
After switching-on, the ’’SW-10’’ inscription appears on the display, and the Setworks is ready for operation
within a few seconds. The last used board thickness is displayed.
To change the board thickness, enter the new thickness required using the keypad. Press
. The saw head will move down by the preset value (taking into account the kerf value).
The controller panel includes three buttons labeled A, B and C. They are used to store board
thicknesses. To display value stored under any of these buttons, press this button momentarily.
To change the stored setting for any of the three buttons, first turn off power supply to the controller
and then turn it on. When ’’SW-10” appears on the display, press and hold down this button. The
display will show ’’Abc” and horizontal dashes. Push the chosen board thickness memory button (A, B
or C) and enter the desired board thickness using the keypad. If you need to store more board
thickness dimensions, press another board thickness memory button and enter this dimension. After
entering all needed dimensions, confirm this by pressing
. The display should show
"Save" confirming that the changes have been stored.
Position the saw head at the height of the first cut calculated from the top of the log.
Start cutting the material to the required dimension.
Remove the board.
Having completed a cut, press
; the head will automatically go up by the Bump Up value
so that it clears the log or cant when being returned.
If needed, change the required board thickness dimension using the keypad or values stored under the
remaining board thickness memory buttons.
Press
and the saw head will drop by the pre-set board thickness to
the next cut
