Wood-mizer SlabMizer MB200, Operation Manual

Page: 27 / 55

Planer Assembly
Install The Head Stops
3
3-6 WMdoc082019 Planer Assembly
3.5 Install The Head Stops
1. Once the Leg Assemblies are attached to the bed section, next install the Head Stops at
each end of the bed section (4 Stops total) See Figure 3-7 for reference.
2. Make sure the Head Stop’s alignment hole is positioned correctly then secure each stop
with (1) M10-35mm Hex Head Bolt and M10 Washer as shown. Repeat this for all four
End Stops.
3.6 Install The Clamps
1. The Planer includes (4) Clamp assemblies for securing material to the bed. These clamps
ride along the cross rails of the bed section and are secured from underneath using the
clamp bracket plate and (2) star knobs for each clamp. See FIGURE 3-8
2. Position the clamps to best secure the slab being finished.
Alignment Pin
Alignment Pin
Hole
M10-35mm Bolt &
Washer (4 ea.)
Head Stop (4 ea.)
FIGURE 3-7