Maintenance & Alignment
Alignment
3
3-3
PGdoc031914
Maintenance & Alignment
3.2
Alignment
WARNING!
Always turn off and disconnect power before
performing any service to the machine.
Grinder Head Angle
NOTE:
The grinder head angle is set and pinned at the fac-
tory and should not need adjusted unless the grinder is
damaged or major components replaced. If adjustment is
necessary, remove the pin, adjust then drill a new hole and
repin the assembly.
See Figure 3-2.
The grinder head should be set at 15°. To check, install the provided
head angle template to the blade clamp fixture with the notches positioned around the
blade rest pins. Loosen the depth adjustment knob until the grinder head rests on the
template.
If the grinder head does not sit flat against the template, remove the locating pin and
loosen the head angle clamp bolt. Loosen the jam nut and turn the head angle adjust-
ment bolt to pivot the head until it rests flat against the template. Retighten the jam nut
and clamp bolt, drill a new hole if necessary and reinstall the pin. Remove the template
from the clamp fixture.
FIG. 3-2
Head Angle
Clamp Bolt
Angle Template
Depth Adjustment
Knob
PG0005-5
Head Angle
Adjustment Bolt
Locating
Pin
