Setup & Operation
Operation
2
2-15
PGdoc031914
Setup & Operation
Close the grinder hood and adjust the feed rate to the desired speed. The amount of
material being removed will determine the feed rate to be used. If the teeth appear burnt
after grinding, slow the feed rate down.
During the grinding cycle, the display will show the number of teeth complete, the feed
rate (teeth per minute) and the percentage of the cycle completed.
When the teeth quantity value is reached, the grinder will shut off. If the buzzer is
enabled, it will sound for the length of time you designate (
). The control
will display the number of teeth processed for the length of time the buzzer sounds.
When the buzzer/display sounds for the designated amount of time, the control will return
to the Enter Teeth Quantity menu, showing the value previously entered.
Turn the feed rate knob to zero (0), lift the hood and unclamp the blade. Remove the
blade from the grinder and install the next blade.
If the blade has the same tooth quantity as the previous blade, brush several teeth with
red dye and push the green START button to return to the automatic mode setup. Make
depth and index grind adjustments to insure proper grind across the entire surface of the
blade profile. Press the START button again to initiate the next cycle.
If the blade has a different tooth quantity, enter the new value and press the enter key.
Press the escape key to return to the mode selection menu.
Push the red STOP button or the escape key at any time to stop the grinder during a
cycle.
Push the Emergency Stop button when done grinding and turn the control off.
