Setup & Operation
Operation
2
2-11
PGdoc031914
Setup & Operation
Loosen the clamping bolt to extend or retract the blade support arm. Slide the support
tube through the U-bolts so the guides can be positioned under the blade. Tighten the
U-bolts and clamp bolt. Loosen the wing nuts on the blade support guides and adjust so
the blade is positioned between the support posts. Tilt the guides slightly forward in the
direction the blade travels and retighten the wing nuts.
Make sure the blade support does not lift the blade. The blade should sit flat on the clamp
rest pins. Bend the support arm down slightly if necessary to prevent it from lifting the
blade.
See Figure 2-10.
FIG. 2-10
Slide support tube
to desired position
and tighten U-bolts
Bend support tube
down to prevent
support guide from
lifting blade
Tilt blade support
guide slightly in
direction of blade
travel
Loosen clamp bolt
to extend or
retract arm
PG0005-17
