Maintenance
Replacing movable vertical cutter belt
Maintenance
doc081920
5-12
5
13.
Replace the cover plate and collection hose.
Replacing movable vertical cutter belt
This process is very similar to removing and replacing the stationary vertical cutter belt,
but with a few minor differences related to the exterior parts of the machine you need to
remove to gain access to the belt.
1.
Remove the movable vertical cutter chip extractor hose mount.
See Figure 5-13.
2.
Remove rear cover of the movable vertical cutter. The chip extractor hose mount and
hose will come off with the cover.
3.
Remove the outfeed side panel.
The remaining steps in this process are the same as those explained in the section
“Replacing stationary vertical cutter belt” on page 10
FIG. 5-13
Remove hose
mount screws
