Maintenance
Replacing stationary vertical cutter belt
Maintenance
doc081920
5-10
5
Replacing stationary vertical cutter belt
1.
Remove the collection hose and cover plate on the front of the MP260.
2.
Loosen (
do not remove
) 4 cap head mounting screws holding the pulley of the stationary
vertical cutter. These screws pass through slots in the motor mount and fasten into the
cast iron table.
See Figure 5-11.
Use a 6 mm hex wrench to loosen mounting screws one turn
3.
Use a 13mm open-end wrench to loosen the locking nut that secures the tension adjust-
ing bolt in place.
4.
Loosen (
do not remove
) the belt tension adjustment bolt to remove the tension from the
drive belt.
FIG. 5-11
Mounting screws
Motor mount
Motor
Motor pulley
Cutter pulley
Belt
