Setup
MP260 Moulder Assembly
Setup
doc081920
3-2
3
2. Infeed and outfeed table (optional equipment).
Install the infeed table to the moulder
using M8x16 screws with hex socket head and washers (A). Then install the supporting
plate (B) using existing bolts (C). Tighten all fasteners by hand. Using the adjusting
screws (D) adjust the table, so is level and on the same height as the moulder cast iron
table (double check this with a long, straight tube or flat board). Tables should also touch
each other. Tighten all bolts and re-check the table level and height. Repeat all above
steps for the outfeed table.
See figure 3-2.
FIG. 3-2
A
B
C
D
D
