Page 12
Remove the Orifice
Use a
9
/
32
” socket with extension to remove the orifice from
the orifice holder.
Simmer
Orifice
Main
Orifice
ORIFICE INSTALLATION
WARNING
When installing the orifice to the orifice holder, only
pipe thread compound should be used. Do not use
Teflon tape to seal gas connections.
Install the Orifice
Use a
9
/
32
” socket with extension to install the orifice into
the orifice holder.
Install the Burner Assembly
1
Attach the electrode wire to the igniter.
2
Place the burner assembly into the burner pan.
3
Use a T-15 Torx bit to install the screws holding the burner
assembly to the orifice holder, torqued to 24 in lb.
Install the Burner Cap
Place the burner cap onto the burner assembly.
Install the Burner Grate
Place the burner grate onto the cooktop.
BURNER PAN REMOVAL
The burner pan is held to the burner box by the screws that
mount the burner assemblies to the orifice holder assemblies.
To remove the burner pan, first remove all burner grates, burner
caps, knobs, and bezels. Uninstall the unit, and then remove the
burner assemblies.
WARNING
Turn off the power and gas to the product before
starting this procedure.
CAUTION
The unit might be supported by the burner pan. The
unit must be uninstalled if more than one burner
assembly or the burner pan is being removed.
CAUTION
If the gas line is not long enough to stay connected
when the unit is pulled out of the opening, the gas
may need to be disconnected.
Remove All Burner Grates
Lift all burner grates from the unit.
TIP: Remove the center grate first.
CG Contemporary Gas Cooktop Service Manual
service.subzero.com
828389 REV. A 06/2018
11
