Wolf BML, Operating Instructions Manual

Page: 37 / 52

3063527_201308 37
Peak ventilation:
CO
2
sensor diagram
NTC
sensor resistances
Outside temperature sensor, room sensor, supply air sensor,
extract air sensor
Sensor resistances
Temp. °C Resist. Ω Temp. °C Resist. Ω Temp. °C Resist. Ω Temp. °C Resist. Ω
-21 51393 14 8233 49 1870 84 552
-20 48487 15 7857 50 1800 85 535
-19 45762 16 7501 51 1733 86 519
-18 43207 17 7162 52 1669 87 503
-17 40810 18 6841 53 1608 88 487
-16 38560 19 6536 54 1549 89 472
-15 36447 20 6247 55 1493 90 458
-14 34463 21 5972 56 1438 91 444
-13 32599 22 5710 57 1387 92 431
-12 30846 23 5461 58 1337 93 418
-11 29198 24 5225 59 1289 94 406
-10 27648 25 5000 60 1244 95 393
-9 26189 26 4786 61 1200 96 382
-8 24816 27 4582 62 1158 97 371
-7 23523 28 4388 63 1117 98 360
-6 22305 29 4204 64 1078 99 349
-5 21157 30 4028 65 1041 100 339
-4 20075 31 3860 66 1005 101 330
-3 19054 32 3701 67 971 102 320
-2 18091 33 3549 68 938 103 311
-1 17183 34 3403 69 906 104 302
0 16325 35 3265 70 876 105 294
1 15515 36 3133 71 846 106 285
2 14750 37 3007 72 818 107 277
3 14027 38 2887 73 791 108 270
4 13344 39 2772 74 765 109 262
5 12697 40 2662 75 740 110 255
6 12086 41 2558 76 716 111 248
7 11508 42 2458 77 693 112 241
8 10961 43 2362 78 670 113 235
9 10442 44 2271 79 670 114 228
10 9952 45 2183 80 628 115 222
11 9487 46 2100 81 608 116 216
12 9046 47 2020 82 589 117 211
13 8629 48 1944 83 570 118 205
Connect external floating contact to input B5. The speed
is ramped up as set in parameter LM060. The speed is not
ramped down again (control operation) until the contact
switches off. This works in all operating modes (On/Off switch
function).
CO
2
control An external contact can be used to switch the system off or
simply issue a fault; see parameter LM180.
The fan speed is adjusted according to the CO
2
content of the
room air.
Relevant parameters: LM015, LM016, LM160, LM161, LM162
This function is only supported in conjunction with a CO
2
sensor.