Wohler AMP1-S8DA, User Manual

Page: 43 / 76

82 10 30 : A MP x-S 8 S e r ie s U se r G u id e
© 20 13 Wo hl e r Te c hn ol og i e s , In c . A l l r ig h ts re se rv ed .
31
C h a p t e r 3 Audio Configuration
S D I I n p u t s
With typical stereo program material, the moving block display is
normal.
If the signals to the speakers are completely independent, they will
have a correlation result of 0, and the block will be stationary in the
center of the screen. See
Figure 3–10 below for an example.
Figure 3–10 Phase Correlation Display
A mono in-phase signal fed to both right and left speakers would
put block being in the right-most position indicating the left and
right speaker signals are phase-identical.
The block will be on the far left for signals that are completely out of
phase.
2. Press any button to return to normal operation.
SDI Inputs
Selecting SDI Groups and Subgroups
When you select either of the SDI inputs for monitoring, the
Group
button allows you to select which two, four-channel SDI audio groups
to display in the level meters.
When you press the buttons quickly, the selection order follows that
shown in
Table 3–3 on page 32 .
1. Press the
Group
button quickly to select the group and then wait
until the display flashes once.
- Phase +
USO
RESTRITO