82 10 30 :
A MP x-S 8 S e r ie s U se r G u id e
© 20 13 Wo hl e r Te c hn ol og i e s , In c . A l l r ig h ts re se rv ed .
21
C h a p t e r 2
System Overview
M o n i t o r i ng I n p u t s
3.
Channel Selection and Mixing on page 22
.
Monitoring an AES Input
1.
To monitor an AES signal, do one or both of the following:
•
Connect an unbalanced AES signal to the rear panel
AES/
PCM In
1
(BNC), and/or
•
Connect a balanced AES signal to the rear panel
AES Bal In
& Loop Out
(DB-25).
2.
On the front panel, press the
Input
button until the LCD screen
displays the corresponding input you want to monitor:
•
AES1
AES1
AES1
AES1
for an unbalanced signal (connected to BNC 1).
•
AES2
AES2
AES2
AES2
for a balanced signal (connected to the DB-25).
3.
Refer to
Terminating/Unterminating Inputs on page 35
to check/
set your termination settings.
4.
Channel Selection and Mixing on page 22
.
Monitoring an SDI Input
1.
To monitor an SDI signal, do one or both of the following:
•
Connect an SDI signal to the rear panel
SDI In 1
(BNC), or
•
Connect an SDI signal to the rear panel
SDI In 2
(BNC).
2.
On the front panel, press the
Input
button until the LCD displays
the corresponding input you want to monitor:
•
SDI1
SDI1
SDI1
SDI1
for a signal to the
SDI In 1
(BNC), or
•
SDI2
SDI2
SDI2
SDI2
for a signal to the
SDI In 2
(BNC).
Table 2–8
AES Input to Channel Relationship
AES BNC Connector
Channel Outputs
1
1 and 2
2
3 and 4
3
5 and 6
4
7 and 8
USO
RESTRITO
Summary of Contents for AMP1-S8DA
Page 10: ...USO RESTRITO...
Page 54: ...USO RESTRITO...
