Wohler AMP1-S8DA, User Manual

Page: 32 / 76

8 21 03 0 : A MP x-S 8 S e r ie s U se r G u id e
© 2 01 3 Woh le r Te ch no lo g ie s, Inc . A ll ri g ht s re s e r v ed .
20
C h a p t e r 2 Sy st em O v e r v i e w
M o n i t or i ng I n p u t s
Monitoring Inputs
System Overview
The following simple instructions will allow you to get your AMPx-S8
Series monitor up and running quickly; that is, you will be able to
monitor any single input through the monitor’s internal speakers.
Referring to the AMPx-S8 Series rear panel diagrams ( Figure 2–5 and 2–
6 on page 14 ) and the front panel controls ( Figure 2–1 and 2–2 on page
9 ) follow the instructions below by signal/connector type.
Monitoring an Analog Input
1. To monitor an analog signal, connect the analog input to the rear
panel
Balanced Analog In
(DB-25) connector.
2. On the front panel, press the
Input
button until the LCD screen
displays Analog Analog Analog Analog .
6 Custom Settings for Alternate Scales
7 Not Used
8
For software Upgrades Only
9
Table 2–7 Reference Setting Values and Definitions
Position
Reference Level Function
Analog (dBu) Digital (dBFS)
Example:
Choosing position 2 (0 dBu = -20 dBFS) means an analog input level of
0 dBu will light up the LED segment associated with the digital -20
dBFS value on the bar graph meter and also transition from green to
amber at that segment.
Note: For a complete description of each front panel control, refer
to
Front Panel Controls on page 8 .
For a complete description of each rear panel connector,
refer to
Rear Panel Connectors on page 13 .
USO
RESTRITO