Page
9
be set so that it only controls the Right Volume.
9.
SDI Selection: Press either of these LED buttons to select one of the two
SDI inputs. Note that SDI 1 is selected by default whenever:
a.
The AMP1-16-M is powered up, or
b.
The Send to Unit control is clicked on a remote access.
10.Trim/Menu: Pressing and holding this button for at least three seconds
opens the menu system so you can customize the operation of the AMP1-16-
M.
Rear Panel
Figure 1–2: Rear Panel Layout
1.
Power: The AMP1-16-M uses a standard IEC power cord for the 100 to 240
VAC ±10%, 50/60 Hz power connection.
2.
3G/HD/SD-SDI Inputs: These two BNC connectors accept the 3G/HD/SD-
SDI input signals.
3.
3G/HD/SD-SDI Outputs: These BNC connectors output regenerated
replicas of the two 3G/HD/SD-SDI input signals.
4.
Selected 3G/HD/SD-SDI Re-Clocked Output: This BNC connector re-
clocks the selected 3G/HD/SD-SDI input signal.
5.
Ethernet: The Ethernet port can connect to either a LAN or a PC to let you
customize the AMP1-16-M configuration. It will also allow you to copy
configurations from one AMP1-16-M to another. Lastly, it can be used to
update the AMP1-16-M software and firmware. Refer to Chapter 3, Appendix
A, Appendix B and Appendix C for details.
6.
Analog Outputs: These XLR connectors provide two channels of balanced
analog outputs. The source of these signals is the mix of audio monitored by
the internal speakers.
