Page
20
d.
Lowering Treble compensates for high frequency pre-emphasis or
removes sibilance effects. Increasing Treble will add “sizzle” to the
sound and bring high-pitched sounds out of the mix.
5.
In the
Speaker Mute
area, click to select one of three speaker
configurations:
a.
Never: Never mute the speakers even when headphones are
connected.
b.
Phones: Only mute the speakers when the headphones are
connected.
c.
Always: Always keep the speakers muted. This option may be useful
if you only want to monitor audio externally, through the XLR audio
outputs on the rear panel.
6.
In the
Analog Output
area, click to select one of three output volume
options.
Fixed Line Level
is exclusive of the other two:
Note:
Note, if the
Analog Output
is set to Controlled and the
Speaker
Mute
is set to
Always
, then plugging in the
headphones will cause the analog
outputs to mute.
a.
Fixed Line Level: The volume of the output is fixed to the volume of
the corresponding inputs.
b.
Volume/Balanced Controlled: The volume of the outputs is
controlled by the
Volume
and
Balance
knobs on the front panel.
c.
Trim Controlled: The analog outputs are controlled by the Trim
settings.
7.
In the
Audio Muting and Delay
area selects any combination of Non-Audio
or PA Header.
Note:
The AMP1-16-M detects PA headers that represent encoded data
streams.
8.
For the
Delay
, click either
No Delay
, or click the up or down arrows to either
increase or decrease the amount of audio delay time.
9.
In the
Speakers/Headphones
area, click either
Not Trim
Controlled
to
eliminate trim control altogether,
Always Trim Controlled
to enable trim
control in both the
Trim Screen
and
the
Main Screen
, or
Only When in Trim
Screen
to enable trim control only in the
Trim Screen
.
10.In the
Volume Control
area, select the way the
Volume
and
Balance
knobs
should operate:
a.
Volume/Balance: This setting selects normal Volume and Balance
control operation as labeled on the front panel. This is the default.
b.
Left/Right Volume: This setting reconfigures the Volume control to
work as a Left Volume control and the
Balance
control to work as a
Right Volume control.
11.In the
Screen Brightness
area, the select the screen brightness for each
screen and the duration for the screen saver.
a.
Left/Right: Either click the down arrow to increase or decrease the
screen brightness value, or click the field and type in a value.
