Page
52
may take a few minutes for the DHCP negotiations to take place. You may
press the Refresh button in the Wohler AMP1-16-M Manager program as
often as you like until the unit appears. See Figure B-1 below.
Figure B-1: AMP1-16-M Manager
10.Once the unit appears, select it and complete any desired operations as
described elsewhere in this manual. If the unit fails to appear after a few
minutes, double check your connections and the instructions above about
disabling unused Ethernet ports.
11.When finished, be sure to disable the Direct Mode on the unit, and return it
to the previous Ethernet settings either through the Windows software and
the Configure IP function, or through the Version and Ethernet Menu as
described previously.
12.Enable any network interfaces on the computer that were disabled, and
restore any settings that were changed.
13.Turn off the unit.
14.Shut down the computer.
15.Disconnect the computer from the unit.
Of course, if you are familiar with setting compatible static IP addresses and
subnets in both your host computer and the AMP1-16-M, that option is open to you
as well. You may use either an Ethernet patch cable or a crossover cable for the
connection.
