The back panel has the connections and button shown in the following figure.
Interface
Qty.
Description
Cable
1
Connect to uplink CATV network
TV
1
Connect to STB or TV by Cable
Ethernet
LAN 2
Ethernet LANn ports for connecting to PC
，
can work on
Router Mode. WAN connection can get the IP address from
upper-layer device.
STB 2
Ethernet ports for connecting to PC, the user-side IP
address is obtained through the upper-layer device.
Power Connector
1
Power connector
Power Button
1
Power On/Off
Reset 1
Reset
button
WLAN 1
Wifi
button
Front Panel
The router front panel has the status LEDs shown in the following figure.
LED
Description
POWER
Solid green. Power is supplied to the EOC slave.
SYS
Solid green. System has started.
Blinking green. The EOC slave is starting up.
LOOP
If the loop happened the LOOP led will on
LINK
•Solid green. The CABLE port has detected a link with the EOC
Master by coaxial cable network.
•Blinking green. Data is being transmitted or received.
•Off. The unit is off or there is no link established.
LAN1-2
•Solid green. The LAN port has detected an Ethernet link with a
device such as a computer.
•Blinking green. Data is being transmitted or received.
•Off. No link is detected on this port.
STB1-2
•Solid green. The STB port has detected an Ethernet link with a
device such as a computer.
•Blinking green. Data is being transmitted or received.
