Bridge, VLAN ID is Null)
5.1.2 Default WAN Connection and Router Mode
There is a default WAN connection, 1_INTERNET_R_VID_ as below.
It works on Router Mode, DHCP, VLAN Disable.
LABEL DESCRIPTION
Network Name
Name of the WAN connection, you can add a new WAN connection or
edit a exist WAN connection
Mode
Bridge or Route mode.
NAT
Enable or disable NAT function
Connect Type
You can use DHCP, Static and PPPoE mode.
MTU
maximum transmission unit (MTU in bytes)
VLAN ID
If you enable VLAN then enter the VLAN ID here.
Service
TR069, INTERNET ,R069_INTERNET
VLAN Enable
Enable or disable the VLAN
VLAN ID
VLAN ID value
Port Binding
Binding the port with the WAN service
(Default WAN Connection in Router Mode have bound with all ports in
default. If you setup new Bridge Mode WAN Connection, you can bind
the port and de-bind the port from the Router MODE WAN
Connection.)
Router Mode:
When connection type is router mode, you can obtain WAN side IP in three
ways. The mode of obtaining an IP address can be set to DHCP, static, or PPPoE.
1) In DHCP mode, the IP address is dynamically obtained.
2) In static mode, the IP address is set statically. You need to enter the IP address,
subnet mask, IP addresses of the active and standby DNS servers, and default
