After ~10 seconds all the four LEDs will be blank, which is signing that the device is not powered
by the AC voltage further.
REL.1
REL.2
REL.3
REL.4
WAN
IMPORTANT!
THE AC POWER INPUT WIRES ARE STILL CONNECTED TO THE DEVICE. THEREFORE DO
NOT OPEN THE DEVICE ENCLOSURE UNTIL NOT REMOVED THE AC POWER FROM THE
PLUG OR THE POWER SOURCE!
The device can be started anytime again by adding the power source for the device (connect the
AC power plug to the electricity network). The device will be operating as it is written in the
Installation Manual, Chapter 2.2.
5.4 Backup device settings
The modem settings are automatically stored by the OpenWrt
®
system, but there can be other
situations when you need to restore the settings to a previously saved settings. You can save these
settings to your computer or restore back to the modem anytime by following the next hints.
Open the
System
menu,
Backup / Flash Firmware
menu.
