26
Original operation manual
AIRCOMBI
AirCombi_BAoDB_en_1701 • rs
Transport, installation and assembly
4 Transport, installation and assembly
The machine left the factory in flawless condition and was appropriately
packed for transportation.
Check the machine for any damage in transit and for completeness on
receipt
.
4.1 Transportation
Please follow these notes when transporting the machine:
➤
Ensure sufficient load bearing capacity of lifting gear and lifting tackle
when loading the machine. The dimensions and weight of the machine
can be found on the machine card or on the type plate.
➤
The machine may only be lifted by the carrying handle (Fig. 7, no. 6) or
by the special eyebolt. The lifting eyes are only designed for the weight
of the high pressure pump. Do not use them to lift the entire machine
(including accessories, hoses or frame)!
➤
Secure the machine (high pressure pump including frame and/or other
accessories) properly for lifting and loading the machine.
➤
Do not transport any unsecured objects (e.g. material containers, tools)
with the machine.
➤
Never stand under suspended loads or inside the loading area.
There is a risk of death!
➤
Secure the load on the transport vehicle against slipping and falling off.
If the machine had already been in operation, please observe the following:
➤
Disconnect the entire power supply – even for short transportation dis-
tances.
➤
Empty the machine before transportation – fluid residues may escape
during transportation despite this measure.
➤
Remove all loose components (e.g. tools) from the machine.
➤
Assemble the parts or fittings dismantled for transport purposes before
start up and in compliance with the intended use of the system.
4.2 Installation location
The machine can be installed inside and outside spray booths. However,
outdoor installation should be preferred in order to avoid contamination.
WARNING
If the machine is used outside during a thunderstorm, a lightning strike
can cause a life-threatening situation for the operating personnel!
➤
Do not operate a machine outdoors during a thunderstorm!
➤
The machine owner must ensure that the machine is equipped with
suitable lightning protection equipment.
Set the machine up horizontally on a foundation that is flat, firm and
vibration-free. The machine must not be tipped or tilted. Ensure that all
operating elements and safety features are easy to reach.
