19
www
.wittur
.com
Changes can be made without notice
PM.2.004922.EN - 810-000-000 SRS DC-PWM
©
· Edition 22 July 2020
7.3 SPEED PROFILE REGULATION TRIMMERS (WITHOUT HANDSET)
To set up both opening and closing speed profiles there are four trimmer on the printed board as shown in the following picture:
•
[HI-OPN] trimmer sets the high opening speed (turn-ing it clockwise will set the high opening speed from the minimum speed
value to the maximum speed value)
•
[LW-OPN] trimmer sets the low opening speed (turn-ing it clockwise will set the low opening speed from the minimum speed value
to the maximum speed value)
•
[HI-CLS] trimmer sets the high closing speed (turn-ing it clockwise will set the high closing speed from the minimum speed value
to the maximum speed value)
•
[LW-CLS] trimmer sets the low closing speed (turn-ing it clockwise will set the low closing speed from the minimum speed value to
the maximum speed value)
Note
: the trimmer set value is saved in permanent memory only if the trimmer stays inactive for minimum, 2 seconds.
7.4 REVERSING SYSTEM FORCE SETTING (WITHOUT HANDSET)
The reverse motion torque parameter sets the sensitivity degree to detect an obstacle during the door closure, thus giving the reopening
command. The parameter's value can be manually set through the [IM] regulation trimmer (turning it clockwise will set the reversing
system force from the minimum value to the maximum value)
Please note that a minor sensitivity corresponds to higher values and vice versa.