Assembly
V.. / NV.. / CV..
en-16
2022-D059517
Revision: 05
For the version with a
locking screw
[A], turn the screw into the adapter plate [B].
For screw size and specified tightening torque, see Table "Tbl-9".
5.3
Mounting the gearbox on a machine
Center the gearbox in the machine bed.
Apply threadlocker (e. g. Loctite
®
243) to the fastening screws.
Mount the gearbox so that the identification plate can still be read.
The specified screw sizes and tightening torques can be found in Chapter 9.2 "Specifications
for mounting to a machine".
If your gearbox is equipped with a liquid-cooled adapter plate, the separate manual "Cooled
adapter plate" (doc. no. 2022–D063351) applies for this. The manual will be provided by our
Sales / Customer Service department on request. Please always provide the serial number.
WITTENSTEIN alpha GmbH
offers corresponding mounting kits for gearboxes in
Hygienic
Design
. The separate instructions "Hygienic Design Instruction Sheet, Mounting Kit" (Doc. no.
2022–D062618) are valid for this. The manual will be provided by our Sales / Customer Service
department on request. Please always provide the serial number.
5.3.1 Mounting with through-holes
Width across flats [mm]
5
8
10
12
Tightening torque [Nm]
10
35
50
70
Tbl-9: Tightening torques for the locking screw
Observe the safety and processing instructions for the threadlocker to be
used.
If your gearbox is equipped with reverse centering for motor-
side installation [M] on a machine, you will find more
information in the separate manual "Reverse centering device
for motor-side installation" (doc. no. 2022–D063062). The
manual will be provided by our Sales / Customer Service
department on request. Please always provide the serial
number.
We recommend doing without washers as long as the
material of the screw surface features sufficient interface
pressure.
Fasten the gearbox on the machine with the fastening screws
through the through-holes [M].
M
M
M
M
