Wisenet TNF-9010, User Manual

Page: 16 / 28

installation & connection
16_
installation & connection
Power Supply
Use a screwdriver to connect the + and - lines of the power adaptor to the provided power terminal block,
and then insert them in the power port (DC12V).
J
`
You must connect the power terminal block connected with a DC12V power cable to the power port of the camera before
plugging the power plug into the power socket.
` If the power sources for PoE and DC 12 V are simultaneously turned on, the device power will be supplied by both of PoE and
DC 12 V.
-
It is advisable to use only one power source from PoE and DC 12V.
`
Be careful not to reverse the polarity when you connect the power cable.
` If you want to connect an external device, you must turn off the external device before proceeding.
Power Cable Specification
In case of DC 12V Input:
Wire Type (AWG) #22 #20 #18
Cable Length (Max.) 10m 16m 25m
Network Cable Specification
Item Contents Remark
Connector RJ45 (10/100BASE-T)
Ethernet 10/100BASE-T
Cable Category 5e
Max Distance 100 m DC Resistance ≤ 0.125 Ω/m
PoE Support IEEE 802.3af
CONNECTING WITH OTHER DEVICE
Monitor for installation
Power
PoE Router
Ethernet
J
`
The Test Monitor Out port of the product is provided for easier installation, and is not recommended for monitoring purposes.
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Powering and networking
Connect the PoE device with the PoE port of the camera.
J
`
Connect and use a PoE enabled router.
`
Use a PoE device that complies with the IEEE 802.3af standard.
`
If you connect using an PoE enabled router, you don’t need a separate power supply cable to power it on.