TextAlert
IV
User Manual
This manual covers the basics of TA
IV
installation and programming. Please refer to
individual sensor manuals, or request assistance from your WirelessAlert agent, for correct
operation of various sensor devices with TA
IV
.
Figure 2: WIrlelessAlert Sensors
Peripherals
TextAlert
IV
peripherals include a wide range of GSM and 433MHz devices suitable for
optimising TA
IV’s
functions and operation range, namely: Repeaters, high gain antennae,
signal adapters, Battery UPS, and Solar Panels.
Please contact your WirelessAlert agent for details of peripherals available or visit the
Products / Peripherals
page on the WirelessAlert website.
4 Hardware Installation
Please note:
You will need to identify a suitable location to install the TA
IV
. The location
must be nearby to a wall plug to allow for the TA
IV
power charger to be plugged in. The
location must also be discreet to prevent unauthorised access to the unit. If you are going
to connect the siren to the unit then take note that you may have to run a cable from the
unit to the final location of the siren.
Hint:
Do not permanently secure the unit in a particular location or run cabling for the siren
until you have successfully completed the set up and booting procedures. There may be
unforeseen factors (e.g. poor cell phone reception) that will require you relocating the unit
to a more suitable location.
4.1
Set-Up Procedure
Please follow the steps below carefully:
•
Locate the following box kit components: TA
IV
unit, Power Charger, GSM antenna,
433 Mhz antenna, Remotes
•
Connect the
GSM Antenna (
Warning:
finger tighten only!).
Copyright InFocus Trading 111 cc, 2009
6
12 Volt Power
charger
433 MHz antenna (labelled with
sticker)
GSM antenna
Remote control keyfobs
Base Receiver - TA
IV
