TextAlert
IV
User Manual
Password#3#1#
Turn on internal microphone to “listen in”
Password#3#0#
Turn off internal microphone
Password#4#1#
Turn on intercom function
Password#4#0#
Turn off intercom function
Password#5#1#
Activate the Relay
Password#5#0#
Deactivate the Relay
Password#10#----------#
Add sms recipient 1 (where ---------- is the recipient’s cell phone number)
Password#11#----------#
Add sms recipient 2
Password#12#----------#
Add sms recipient 3
Password#13#----------#
Add sms recipient 4
Password#14#----------#
Add sms recipient 5
Password#15#----------#
Add phone call recipient 1
Password#16#----------#
Add phone call recipient 2
Password#17#----------#
Add phone call recipient 3
Password#18#----------#
Add phone call recipient 4
Password#19#----------#
Add phone call recipient 5
Password#30#----------#
Set new password (max 6 characters)
Password#31#----#----#
Set auto arm time and auto disarm time
Password#32#1#
Set siren to sound when alarm triggered
Password#32#0#
Set siren to not sound when alarm triggered
Password#33#1#
Enable – “relay on for 3 minutes during alarm”
Password#33#0#
Disable – “relay on for 3 minutes during alarm”
Password#37#--#
Set the Arm delay time (00 – 99 seconds)
Password#38#--#
Set the before Alarm delay time (00 – 99 seconds)
Password#50#--
#-----------------#
set for 50…….65 (wireless
zones 1 –16)
Set up wireless zone status and custom message (Status 1 = enabled, 0 =
disabled and 2 = 24 hour auto arming).
Message = text message of up to characters
Password#66#-#-----------#-#
set for 66 …..70
(wired zones 1-5)
Set up wired zone status, custom message and type of contact. Status 1 =
enabled, 0 = disabled and 2 = 24 hour auto arming. Message = text
message of up to characters. Type of contact = 1 for send sms when
triggered and 0 for do not send sms when triggered
Table 5:
TextAlert
IV
Advanced SMS Commands
SMS Command
Action / Configuration
Password#20#
This will request an armed / disarmed status report from TA
IV
Password#21#1#
Turns on the “siren chirp once for arm and twice for disarm” function
Password#21#0#
Turns off the “siren chirp once for arm and twice for disarm” function
Password#34#1#
Turns SMS command/configuration reply on
Password#34#0#
Turns SMS command/configuration reply off
Password#40#----------#
Sets the Central Alarm Centre Cell Phone Recipient number to ----------
Password#41#----------#
Allows for Unique ID number (or message) to be set for the unit where
---------- is the ID number that will appear in the SMS sent to the Central
Alarm Centre above
Password#42#----------#
Sets the cell phone number to send missed call confirmation when unit is
armed, where number is ----------
Password#43#----------#
Sets the cell phone number to send missed call confirmation when unit is
disarmed, where number is ----------
11 TextAlert
IV
Additional Features
11.1 Recording a Voice Message
TextAlert
IV
can be programmed to store a 10 second voice message. When the TA
IV
goes
into alarm state then this message will be played back as a voice message to cell phone
recipients who answer the voice call. While the call is connected the recipient can press
the “*” key to listen to the message again.
To record a message, press and hold in the
Record
push button switch on the back panel
of the TA
IV
. The internal microphone is located on the right hand side of the TA
IV
. Speak
Copyright InFocus Trading 111 cc, 2009
16
