TextAlert
IV
User Manual
be set as either Away or Stay type. Outdoor sensors would typically be linked to an Away
zone (always armed) while an indoor sensor would be linked to a Stay zone (disarmed
when owner is at home, to allow home owner to move around inside their home, with the
assurance that outdoor Away perimeter zones will still detect any approaching intruders).
Before linking sensors onto zones, make sure to record the type of zone and the other
important information for each sensor as per Table 1 above in the SID document
(
Appendix 2
).
The procedure for linking sensors onto zones is outlined below.
Note:
When using magnetic door/window contact sensors, consider linking them to Away
zones, particularly if you wish to have perimeter protection while inside your home. If an
intruder should then attempt to gain access to your home through a door or window, while
in Stay arming mode, then the particular magnetic contact on the door or window will still
trigger the alarm and alert you.
Figure 5:
VA
outdoor
sensor,
indoor
Sensor and magnetic door contact.
8.1.1 Linking Sensor onto an Away Zone
•
Prepare the sensor you wish to link onto TA
IV
.
•
Press and hold the reset button on the back panel of the TA
IV
for 2 seconds.
•
The Status LED will shine RED.
•
Activate the sensor you wish to link with Away zone (make sure the sensor is at
least 1.5m away from the TA
IV
when activating it).
•
"
Status
" LED will flash once or twice to indicate sensor has been linked to the next
available zone on TA
IV
. Make sure to record details as per Table 1 above in the SID
document.
•
After 20 seconds the Status LED will return to GREEN.
•
Remove battery from the ‘linked’ sensor so that it does not accidentally interfere
while linking additional sensors onto further Zones.
•
Link additional Away zone sensors using the above procedure.
8.1.2 Linking Sensor onto a Stay Zone
•
Prepare the sensor you wish to link onto TA
IV
.
•
Press and hold the reset button on the back panel of the TA
IV
for 2 seconds.
•
The Status LED will shine RED.
•
Press and release the reset button again, once.
•
The Status LED will change to Orange.
•
Activate the sensor you wish to link with Stay zone (make sure the sensor is at least
1.5m away from the TA
IV
when activating it).
Copyright InFocus Trading 111 cc, 2009
11
